Manufacturing Engineering Technology Minor

Print Degree Planner (opens a new window) |

Department of Engineering Technology, College of Sciences and Technology

28-34 credits

Qualification For Minor

*The MET minor was designed for non-ETEC majors. The only ETEC majors that may work on the minor are EET and ID. Meet with a Department of Engineering Technology advisor to declare a Manufacturing Engineering Technology minor.

Grade Requirements

A grade of C- or better is required for a student’s major or minor courses, and supporting courses for majors and minors.

Requirements

❑ ETEC 112 - INTRODUCTION TO ENGINEERING, DESIGN AND GRAPHICS
❑ ETEC 113 - INTRODUCTION TO COMPUTER-AIDED DESIGN
❑ ETEC 220 - INTRODUCTION TO ENGINEERING MATERIALS
❑ ETEC 246 - MANUFACTURING PROCESSES I
❑ ETEC 325 - MANUFACTURING PROCESS PLANNING
❑ One of the following sequences:*
General Manufacturing (9 credits):
ETEC 322 - NUMERICAL CONTROL OPERATIONS
ETEC 333 - POLYMER TECHNOLOGY
Engineering Design (9 credits):
ETEC 224 - APPLIED ENGINEERING STATICS
ETEC 225 - STRENGTH OF MATERIALS
Computer Aided Manufacturing (15 credits):
ETEC 222 - FOUNDRY, FORMING AND JOINING
ETEC 322 - NUMERICAL CONTROL OPERATIONS
ETEC 427 - TOOL DESIGN
One course from:
ETEC 426A - ADVANCED COMPUTER NUMERICAL CONTROL - SURFACING AND CONTOURS
ETEC 426B - ADVANCED COMPUTER NUMERICAL CONTROL - MILL/TURN
ETEC 426C - ADVANCED COMPUTER NUMERICAL CONTROL - HI-SPEED MACHINING
Engineering Polymers (10 credits):
ETEC 333 - POLYMER TECHNOLOGY
ETEC 334 - REINFORCED PLASTICS/COMPOSITES
❑ Students are advised that MATH 125, PHYS 122 and CHEM 121 are pre-requisites to some of the required courses and should be taken prior to the required courses.

University Graduation Requirements

General University Requirements (GURS)
Writing Proficiency Requirement (WP)
180 Minimum Total Credits
60 Minimum Upper Division Credits
Residency Requirement
Minimum Grade Requirements
Final Quarter Requirement